INSTALLATION:

T he LifeForce Dynapac-LP has been designed for a
plug-n-play installation.  No APU can be installed, or removed
in less time.  At less than 200 lbs, no specialty lift equipment
is necessary and because of it's smaller size and weight, it
can be positioned in more places on the truck.  Mounted on
the depth axis, the frame space width required is 21 inches.  
In many cases, it will also fit between the frame rails behind
the cab.  Two small penetrations are made in the floor of the
cab for wire pass-throughs.  AC installations vary -
depending on the model selected and the configuration of
the truck they are being installed in.  Please call for specifics.
The installation causes no significant damage to the truck that cannot be easily repaired.  When the APU is
removed, the minor repairs necessary can be done in minutes by almost anyone.  So you have the option to
either leave the APU with the truck when it is re-sold, install it on a new vehicle you buy, or refresh it and sell
it to another trucker.   

Optional portable AC units are available that require no installation whatsoever.  These work especially well in
the larger, wider cabs, where space is not as much of an issue.  The portable units can be moved anywhere
within the cab, but they work best when positioned near the front seats - facing to the rear.   When in use, the
exhaust hose is rolled up into one of the windows.  With no ducting, these units cool extremely well.  

Propane fired or ceramic heaters are available.  The ceramic units are portable, so they can be positioned
almost anywhere in the truck.  
America's 1st Alternative-Fuel Truck APU
Specs & Installation
Motor/ Generator
Generac/ LifeForce Single Cylinder
407cc  Industrial Spec. Motor/ 4500
Watt 37.5 Amp Generator
Output
120 VAC, 30 Amps continuous, 4.5Kw
peak
APU Dimensions
Width: 20.5" Depth: 27" Height: 18"
(Muffler is mounted under truck
frame rail and not included in
dimensions)
AC Dimensions
Varies by model - Call
Cooling
8,500 BTU to 14,000 BTU (10K
standard)
Heating
1500 watt internal electric Heater or
independent propane fired heater
APU Weight
240 lbs. (plus mounting hardware)
AC Weight
63 to 140 lbs. - varies by model
Fuel Consumption
.30 - .50 Gal./hr. - load dependent.
Average: .40 gal/hr.
Fuel Tanks: DOT  20,
33.5 or 43.5 lb. Larger
ASME permanent
mount available.
Single or dual DOT - 4.76 gal, 8 gal, or
10 gal. - can be mounted together or
separately.  ASME tanks up to 50
gallons permitted as Materials of the
Trade - no DOT restriction.
Additional                       
Accessories
Tanks, Block & Battery Heaters, Tank
Heaters, Steps, shore power.
SPECIFICATIONS - LifeForce Dynapac APU:
Copyright 2009.  All rights reserved.  LifeForce Energy Corporation
485 Victor Way, Salinas, California 93907. (831) 422-2290  (831) 422-2299-fax